How do I connect the Flavour Bottle to the sodastream ULTIMATE Multi-drink™?

To properly connect the flavour bottle, check out this 'How-To' video and the following steps:

1. Select your desired Flavour Bottle*.
2. Remove the Flavour Bottle Cap (set aside for future use or recycle) and seal.

3. Assemble the Flavour Connect Cap according to the use manual. 

   Note! 1. The Cap of the Flavour Connect Cap should not be removed while in use (only remove for cleaning purposes). at any stage. 2. The Flavour Connect Cap is not a ‘stand-alone’ product that can be used as a pump outside the FOUNTAIN™ drink maker. 

4. Tightly screw on the Flavour Connect Cap to the Flavor Bottle. 

   Note: When replacing one Flavour Bottle with another, use a dry paper towel to cover the nozzle to avoid dripping.

5. Open the Flavour Bottle Door on the front face of the Sparkling Drink Maker.
6. Attach the Flavour Bottle by pushing the top of the Flavour Connect Cap up and into the Flavour Bottle Slot.
7. Once the Flavour Connect Cap is in the slot, turn the Dispense Nozzle left until it clicks and locks into place.
8. When successful, the Flavour Indicator will light up. 
   
9. For first-time use of your new Sparkling Drink Maker, run a rinse cycle before making your first drink.
   • Place a small sized vessel below the Dispense Nozzle. Press the Carbonation Level Button repeatedly until the light indicator lands on Still (no carbonation).
   • Set the Flavour Dial in setting #2.
   • Start the rinse cycle by pressing the Activation Button once.
   • Dispose of the liquid and continue to MAKE YOUR DRINK. Priming steps below are for future Flavour Bottle installation
     
10. For best results, whenever attaching a new Flavour Connect Cap to a Flavour Bottle, follow the priming steps to remove any air from the pipeline**;
    1. Place a glass under the Dispense Nozzle.
    2. Set the Flavour Dial on “Boost” (B).
    3. Press the Activation Button x 1 or 2 times until flavour is dispensed:
       Boost x 1 for Zero Sugar / Diet flavours. Boost x 2 for all other flavours.
    4. Rinse the glass and continue to drink making.
       

* Use only the new 440 ml transparent Flavor Bottle with a pour cap. You can also make unflavored sparkling water by setting the Flavor Dial to “0”. 

** Priming is only necessary during first use of the Flavor Bottle or if the contents of the Flavor Bottle are fully exhausted. Otherwise, subsequent uses of a primed Flavor Bottle, even when switched out, should not require repeated priming.